Tutorial: Make a Bed for Barbie

If you are new to the blog, welcome.  You have reached an archived tutorial.  We have many more tutorials-just check the right side bar.  We typically put up new blog post twice daily so there is always something new and fresh here.  Click HERE and see what’s new today…

My sister in law has been in love with dolls ever since I met her.  One of her favorite collectibles is Barbies.  She’s been a grandma for 18 years and has 15 grand children but just until recently she never had girls that loved Barbies….but-if this picture is any indication, that is changing.

The last time I talked with her, she was getting in the mood to sew some Barbie clothes in hopes of turning them into Barbie lovers.

When my girls were growing up I made gobs and gobs of Barbie clothes…I made Ken clothes too.  One of the kids’ favorite things I made were Barbie sleeping bags or beds.  I thought I would write out the pattern for my sister in law and then thought why not write the pattern and post here as there might be others of you looking for a quick gift and a way to use up some fabric scraps.

You will need some scrap fabric, scrap quilt batting and a bit of fiber fill.

Here’s a completed bed.  Aren’t they kind of cute??


I put strings on the ends of mine so they can be rolled up and tied like this if kids would like.

Here’s the instructions to make one:

You will need one 14″ x 5 1/2″ piece for the backing.  Cut a lining piece slightly bigger than that.  Cut a batting piece the same size.  For the pillow cut one 4″ x 5 1/2″ piece cut batting and backing pieces slightly larger.


Machine quilt the pieces.  I did a cross hatch design.


Trim the pieces so that they are 14″ x 5 1/2″ and 4″ x 5 1/2″. Press a 1/4″ seam up to the back side of the pillow piece as shown.


Layer the pillow right down  onto the bed so that right sides are together.  Pin in place as shown.  Sew the pillow down if place going from pin to corner to corner to pin.


Trim the corners.


Turn pillow part right side out.  Stuff lightly with fiber fill.


Hand sew the opening closed.


Sew 6″ fabric scraps together.  Trim piece so that it is 10″ x 5 1/2″.  Layer with a larger piece of batting and backing.


Cut a larger piece of batting and backing.  Layer and machine quilt.


Cut a 2 1/2″ piece of fabric. Iron in half.  Sew it down along the top edge as shown.


Turn the binding piece around to the back and stitch in place just as you would when binding a quilt.


If you want to be able to roll it up and tie it, now is the time to add strings.  I cut mine 20″ long.  I turned over the edge and sewed to prevent raveling.  Pin in place along the bottom edge opposite the pillow on the BACK side.  Pin the ends of the strings down too.  If you don’t they will likely get sewn into the seam (Don’t ask how I know this.)


Layer the RIGHT side of the pieced unit onto the BACK side of the sleeping bag with right sides together.  Pin in place making sure that the top matches up to where we clipped the seam earlier.


Sew around as shown.  Back stitch several times near the clipped area so that the seam doesn’t come loose as the children play.  Clip the corners.


Turn right side out and you have a Barbie bed….make it in camouflage and you have a  bed for G.I. Joe.


When my girls were little they had lots of Barbies…I think I must have make about 10 of these.  They don’t take much time and kids enjoy them.

You can find MANY other free patterns on our site by looking under the free patterns tab at the top of the page under our banner.  Stop by again…